|
Technical Tips: Brakes ( 9 articles)
|
Brake arm set up
(Added : 10/26/2019 10:09:27 PM Hits : 2403 Rating: 10 Votes: 1)
Some confusion about setting up brakes To put things correct, the angle between cable or rod MUST be an Acute or less than 90 deg.
|
Front forks and Brake.
(Added : 2/1/1984 12:00:00 PM Hits : 2762)
My Experience is with half-width hubs but the advice could probably be adapted for other brakes. Before giving up in despair at ever having good front brakes, try checking the following...
|
A Quick Stop
(Added : 7/29/2006 10:28:44 AM Hits : 6686 Rating: 9 Votes: 4)
|
Brake Arm efficienty - a couple of solutions
(Added : 4/1/2000 Hits : 5383 Rating: 8 Votes: 1)
AS we all know, for the most effective brake leverage, the brake arm needs to be just over 90 from the direction of pull with the brake hard on. If it is significantly less or more than 90 then the leverage and efficiency of opera¬tion are reduced.
|
Brakes - assembly tip
(Added : 4/1/1996 Hits : 5036 Rating: 10 Votes: 1)
To ensure good brakes when replacing front wheel for any reason, loosely assemble the wheel in the forks and fit brake cable.
|
Page 1 of 1
Add an Article
|
|
|