Nookys nuts have 5/16 cycle nylock
http://www.nookysnuts.com/catalogue/nut ... bolts.html
BSC thread nightmare
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: BSC thread nightmare
only dead fish go with the flow
-
- Posts: 37
- Joined: Sun Oct 02, 2016 7:34 pm
- Location: Calne Wiltshire
Re: BSC thread nightmare
yes that link worked and I ordered some.
-
- Member
- Posts: 8594
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: BSC thread nightmare
You're right, John, and I do know better, but down in the man-cave with a brew and 'The Afternoon Play' on R4 I can be a bit too laid back.JohnHewes wrote:Spriddler, I thought you knew better!
In my defence I've never had to recut a thread from scratch, just clean up old ones and remove debris at the bottoms of threaded blind holes, especially the 5/16" BSF in ali cylinder heads for the rocker box bolts (see, I do know the size of some of them
![Wink ;)](./images/smilies/icon_e_wink.gif)
![Sad :(](./images/smilies/icon_e_sad.gif)
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'
-
- Posts: 273
- Joined: Fri Jan 01, 1993 12:00 am
- Location: NORTHANTS UK
Re: BSC thread nightmare
And you get a wonderful sense of a job done properly once you have a nice steel helicoil in the Ali.
-
- Member
- Posts: 761
- Joined: Thu Mar 31, 2005 1:00 am
- Location: BERKS UK
Re: BSC thread nightmare
Hi Ade, I suggest you get a set (1/4 to1/2 in) of BSC taps and dies, they are not too dear, a 1/4 in BSW and 5/16 BSF plug taps to clean up crankcase and other threads in alloy, and get any others as the need arises. Tracy tools will send them within 24 hrs, so there won't be much of a delay in your rebuild. Hope this helps, Andy
-
- Posts: 37
- Joined: Sun Oct 02, 2016 7:34 pm
- Location: Calne Wiltshire
Re: BSC thread nightmare
Taps and dues ordered! cheers guys.