I turn again to my helpful friends.
I’m building my G9 from boxes of parts that include duplicates and parts from other bikes. This complicates the job. So far I have 3 copper washers, a cork gasket and two fibre washers that I don’t know what to do with. They are shown here with other parts for scale. Can anyone tell me what they are and where they go?
Unidentified parts
-
- Member
- Posts: 64
- Joined: Thu May 12, 2022 7:43 pm
- Location: British Columbia CANADA
Unidentified parts
You do not have the required permissions to view the files attached to this post.
- dave16mct
- Member
- Posts: 3281
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: Unidentified parts
The cork gasket might be to seal the dynamo agianst the crankcase. I don't think the copper washers fit anything on a twin. The fibre washers might fit the oilpipe banjo fittings, depends on their size.
Dave.
Dave.
-
- Member
- Posts: 64
- Joined: Thu May 12, 2022 7:43 pm
- Location: British Columbia CANADA
Re: Unidentified parts
Good to know. I was worried I’d left out those copper washers somewhere. I haven’t quite got to the rest of it yet but will be sure to check the gaskets when I do.
- griffin
- Member
- Posts: 209
- Joined: Thu Jan 01, 1998 12:00 am
- Location: NOTTINGHAMSHIRE UK
Re: Unidentified parts
Copper washers ...Oil filter housing and caps end of cam tunnel ??
pt nos 023106 015034
http://archives.jampot.dk/book/Spares_l ... s_List.pdf
pt nos 023106 015034
http://archives.jampot.dk/book/Spares_l ... s_List.pdf
- dave16mct
- Member
- Posts: 3281
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: Unidentified parts
Not those though, much narrower.