Gauze oil filter
- Peter Morris
- Member
- Posts: 733
- Joined: Wed Mar 05, 2014 4:21 pm
- Location: SURREY UK
Gauze oil filter
I bought a new oil filter, oil tank gauze type, and found the hole in the brass end is smaller than the one I am replacing. The hole is only 1/4" in diameter.... is that enough, or should I run a drill through it?
You do not have the required permissions to view the files attached to this post.
- ajscomboman
- Member
- Posts: 3981
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: Gauze oil filter
Looking through the sales history hundreds and hundreds have been sold by both AMC Spares and the club with no reports of any engine issues being reported so I think you're safe to use as is. However if there is enough meat to drill out and you'd feel happier then go for it.
- Peter Morris
- Member
- Posts: 733
- Joined: Wed Mar 05, 2014 4:21 pm
- Location: SURREY UK
Re: Gauze oil filter
Thanks Rob,
It came from the club spares so I had a good idea that it would be right..... just seemed strange that the tank outlet/pipes are a bigger bore.
It came from the club spares so I had a good idea that it would be right..... just seemed strange that the tank outlet/pipes are a bigger bore.
- REW
- Member
- Posts: 1366
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: CO DURHAM UK
Re: Gauze oil filter
I ran a drill through the one I bought solely for "there, that seems seems better" reasons as there is plenty of meat there as Rob says. Just take care to catch the swarf, obviously.
Ron
1951 Matchless G3L thumping round the Durham Dales.
1951 Matchless G3L thumping round the Durham Dales.