AJS and Matchless Owners Club Limited

AJS & Matchless Owners Club
Limited

 Home >> Articles >> Electrical Technical >> Dynamos

 Electrical Technical: Dynamos ( 8 articles)


Dynamo regulator
(Added : 8/20/2013 4:23:20 PM Hits : 2050)
I have tried several dynamo regulators, from the original one to V tec, then another one from AC services, a V reg 2..........


Circuit Diagram for most bikes up to 1957
(Added : 10/12/2012 6:04:07 PM Hits : 3607 Rating: 10 Votes: 7) PDF File
This is something that might help if you are having problems with your electrics. It is a circuit diagram that I have created using the wiring diagram that can be found in various AMC publications. I produced it to help me understand how the electrical system works on my two AMC bikes. A circuit diagram, as the name suggests, presents the logic of the electrical circuit without regard to the physical shape of the wiring loom. However to make it easier to relate to the wiring loom I have coloured the connections in the appropriate cable colours and shown where the frame acts as the earth. Fault finding is easier using a circuit diagram.


Extraction of 12 volts from a ’6 volt’ dynamo
(Added : 3/13/2010 6:20:19 PM Hits : 2537) PDF File
The motorcycle world has abounded with rumour and 'fact' on this vexed subject for over 20 years, the extraction of 12 volts from a humble 6 volt dynamo, as used on the majority of British motorcycles (and a few foreigners).


Alignment Of Dynamo Chain - HW Singles
(Added : 12/6/2008 9:48:59 AM Hits : 2718)
A method to establish the correct position of the dynamo locating plate if the plate has been moved or it is believed to be in the wrong position.


Dynamo fitting in H/W singles
(Added : 12/1/1995 Hits : 3500 Rating: 3 Votes: 1)


Dynamo bearing retaining screws - disaster
(Added : 10/1/2000 Hits : 2388) PDF File
Dynamo bearing retaining screws - disaster


Dynamo chain
(Added : 4/1/1999 Hits : 2215)
Dynamo chain


Dynamo - fault and bodge
(Added : 12/1/1991 Hits : 2975)
Many of you will know the symptoms:- The dynamo will not charge unless the cut-out ar¬mature is pressed in by hand, whereupon the charge continues until you back-off to tic¬k over, then it’s back to square one.


Page 1 of 1

Add an Article

Snowplough Set as your default homepage Add favorite Privacy MaxWebPortal   © 2000-2017 Jampot All Rights Reserved. MaxWebPortal.info Snitz Forums Go To Top Of Page