|
|
| Picture: |
pump plunger assembling? |
|
|
| Description: |
does anyone know how to set pump plunger correctly?
before, the oil for the rocker did not flow..
I try to assembly the plunger and put a white mark to the end of plunger to make sure that oil hole at the plunger at the right position, but the result event worse, the oil for the rocker and for the crank shaft did not flow.
thx a lot mate |
| Hits: |
2031 |
| Rating: |
Rating:10 Votes:3 (Rating Scale: 1 = worst, 10 = best)
|
| Added on: |
06 Jan 2011 |
| Posted by: |
beri |
| Comments: |
3 Comment(s) | Rate this picture
|
By
Ludwig
06 Jan 2011
|
FJRIGJWWE9R1PIC_RATING:COMMENTS Hello,
there is nothing to adjust.
Be sure that the location pin fits into the groove.
Have a look into the workshop manuel:
http://www.archives.jampot.dk/Book/Workshop_manuals/Workshop_Instruction_Manual_all_models_1957-1964__HIGH_RES.pdf
(Page 31)
Regards
Ludwig
|
By
Ex-member
06 Jan 2011
|
FJRIGJWWE9R1PIC_RATING:COMMENTS I suspect wrong pump/guide pin.
pump should have 2s stamped on the end.
the wrong guide pin or a very badly worn one will have this effect.
|
By
clive
11 Jan 2011
|
FJRIGJWWE9R1PIC_RATING:COMMENTS the guide pin has a step at the end. The stepped end needs to fit into the the guide (part no 010138) not into the oil pump plunger. If put in the wrong way there is no pumping action.
|
|
Back
|
|
|
Home
>> Pictures
>>
Bikes
>>
Classic Road Machines
>> pump plunger assembling?
