| Picture: |
Rear Wheel bearings 1946 G80 |
|
|
| Description: |
I have just stripped the rear hub of my 1946 G80 to find the bearing configuration as per attached photo, it sure dont look like the one in the parts book, any ideas. the cental spacer is recessed to take the inner part of the inner race. the spindle is 1/2" dia |
| Hits: |
2948 |
| Rating: |
Rating:10 Votes:3 (Rating Scale: 1 = worst, 10 = best)
|
| Added on: |
26 Dec 2010 |
| Posted by: |
bunners |
Large Picture: | Click here for high resolution image |
| Comments: |
3 Comment(s) | Rate this picture
|
By
bjork
27 Dec 2010
|
FJRIGJWWE9R1PIC_RATING:COMMENTS I’d say that’s a diy fix to away from the original one piece spacer/inner race set up using some more common bearings. Looks like it should work fine!
|
By
Peter Lecompte
29 Dec 2010
|
FJRIGJWWE9R1PIC_RATING:COMMENTS Hi, not sure about a DIY fix. i have exactly the same setup on what i thought was a 1949 rigid rear wheel. Interesting and a good photo. It would be good to see the axle and spacer set-up also... Peter
|
By
wilko
14 Jan 2011
|
FJRIGJWWE9R1PIC_RATING:COMMENTS It’s homemade and that spacer should be shouldered down to the inner diameter of the bearings so that it doesn’t bear against the roller cage. I certainly would like the part no’s of the bearings for a future fix!
|
|
Home
>> Pictures
>>
Parts Pictures
>>
Post war singles
>> Rear Wheel bearings 1946 G80
