Picture: |
1950 G80 Dynamo Mounting |
|
|
Description: |
When mounting the dynamo E3AR-A05-1 in the rear engine plates I noticed that there is a large gap around the dynamo. This gap stops the locating strip from butting up against the inside of the plate. Any ideas what could be wrong before i go further? Or is this right? |
Hits: |
2782 |
Rating: |
Rating:10 Votes:1 (Rating Scale: 1 = worst, 10 = best)
|
Added on: |
19 Mar 2013 |
Posted by: |
Peter Lecompte |
Large Picture: | Click here for high resolution image |
Comments: |
1 Comment(s) | Rate this picture
|
By RayRST
20 Mar 2013
|
FJRIGJWWE9R1PIC_RATING:COMMENTS I think somebody has ground out the top of the hole. I will add pictures of my 1948 16M as I have the dynamo off the bike. Yours does not have the slot at the top. I suggest a welding job then grinding smooth to the correct radius. Hope this helps.
Regards
Ray
|
|