Cetre stand spring

msammels · Post by **msammels** » Tue May 20, 2008 6:07 pm

Me with another one now - as my project (500 twin) was a basket case I never saw the original configuration, and it's seems the simple things are the trickiest to fathom...

So anyone tell me how the spring is tensioned; obviously it sits on the same stud as the pivots and the long end hooks round the middle part of itself, but the stubby end goes where please?

mikeydpippin · Post by **mikeydpippin** » Tue May 20, 2008 8:11 pm

mikeydpippin · Post by **mikeydpippin** » Tue May 20, 2008 8:12 pm

Mark,Try TechArticles Cycle parts page 2,The small end fits to the egine plate.I know where your coming from though, i struggled on that one.

laxy · Post by **laxy** » Tue May 20, 2008 11:20 pm

Hi Mark, further to mikeydpippin advice if you do a search the info you need is all there.This applies to a lot of questions that is what the facility is for.Of course, If a question cannot be answered after doing a search then the next line of enquiry is this forum
mind those fingers now!