Hi, I'm looking for a replacement Gudgeon pin for my 1965 model 14 CSR, the club spares only list a pin for the 350 lighjtweight engine (below). Does anyone know if this will fit? The dimensions are 3/4" X 2.37" (60.2mm).The part no. for the 250 042034.
022277 GUDGEON PIN FOR 600/650 TWIN PISTONS ALSO FOR 350CC L/W
Cheers Mark.
Gudgeon Pin - Model 14 CSR
-
- Member
- Posts: 13
- Joined: Thu Aug 23, 2018 11:47 am
- Location: Warwickshire UK
-
- Member
- Posts: 1602
- Joined: Mon Jan 01, 1990 12:00 am
- Location: WEST SUSSEX UK
Re: Gudgeon Pin - Model 14 CSR
pretty sure 022277 should be
0.7499" to 0.7497" diameter - manual spec
62.375 mm length ( sorry mix if units) - measurement
New replacements are not available
The replacement JP piston pins are a tad large on diameter
Pin should fall under its own weight in small end bush with light oil
0.7499" to 0.7497" diameter - manual spec
62.375 mm length ( sorry mix if units) - measurement
New replacements are not available
The replacement JP piston pins are a tad large on diameter
Pin should fall under its own weight in small end bush with light oil
-
- Member
- Posts: 13
- Joined: Thu Aug 23, 2018 11:47 am
- Location: Warwickshire UK
Re: Gudgeon Pin - Model 14 CSR
Thankyou for the information, I was struggling to find the rod length in any of the manuals. The original piston is high compression and +.030, so as a last resort I would have to have to get the cylinder rebored and go to a standard +.040 piston.
According to the manual the 350 lightweight pin is also 3/4" but not sure about the length?
According to the manual the 350 lightweight pin is also 3/4" but not sure about the length?