DYNAMO BRUSH ACCESS
-
Blackcat
- Member
- Posts: 36
- Joined: Mon Nov 03, 2014 11:05 am
- Location: Berkshire UK
DYNAMO BRUSH ACCESS
Hi Guys, I have a 47 G80 with the original E3AR-A05-1 dynamo. I need to check the brushes but can't see how the Bakelite end cap comes off. I have removed the 2 nuts and loosened the clamping strap but the cap won't budge, and I don't want to force it. I assume you have to take off the clutch side, cogs and chains ETC, to totally remove the dynamo, which is a pain!
You do not have the required permissions to view the files attached to this post.
I dunno man - I only just got here meself!
-
dave16mct
- Member
- Posts: 3246
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: DYNAMO BRUSH ACCESS
Perhaps Eamonn can move this to the correct section. This is for the Harris (Rotax engine) Matchless G80.
Dave
Dave
-
SPRIDDLER
- Member
- Posts: 8559
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: DYNAMO BRUSH ACCESS
Graham also asked earlier in the (correct) G80 section yesterday.
viewtopic.php?t=30210
It would seem that the cap is somehow stuck to the dynamo body so to avoid damaging it removal of the dynamo would be best.
Yes it comes out on the clutch side so some some dismantling needed.
viewtopic.php?t=30210
It would seem that the cap is somehow stuck to the dynamo body so to avoid damaging it removal of the dynamo would be best.
Yes it comes out on the clutch side so some some dismantling needed.
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'