Intake Cam to vent cap problem 1959 G12 HELP!
Posted: Wed Oct 02, 2019 2:14 pm
I purchased new cams for my engine a while back. When fitting the round disc(with the hole through it) for the vent into chamber on the primary side, and aligning with the female end of the intake cam , The disc protrudes out too far and the vented cap hits the disc.
The vent cap binds on the disc with a 1/8 gap between cap and engine case.
The disc does not recess into the chamber far enough. Female end of cam has a 10.mm recess and the male side of the disc is 4.5 mm
The Disc is my original from the motor but I fear the cams are wrong. It looks like the female end of the cam is deeper then the male end of the disc thus preventing the proper fit.
Please help, Have I got the wrong cams????
The vent cap binds on the disc with a 1/8 gap between cap and engine case.
The disc does not recess into the chamber far enough. Female end of cam has a 10.mm recess and the male side of the disc is 4.5 mm
The Disc is my original from the motor but I fear the cams are wrong. It looks like the female end of the cam is deeper then the male end of the disc thus preventing the proper fit.
Please help, Have I got the wrong cams????