Page 2 of 2
Re: G2 clutch pushed length
Posted: Wed Jun 19, 2019 6:08 pm
by clanger9
Martin.S wrote:It was always a recommended mod for the Triumphs to cut the pushrod in half and insert a ball bearing between the two halves - not worth the effort on the Matchless?
Shouldn't be necessary on a G2. Mine has the competition 7-plate clutch, it never slips and it's not heavy at all.
Re: G2 clutch pushed length
Posted: Sun Jun 23, 2019 6:01 am
by Richard Hyatt
Thank you for your thoughts .
We've now got new plates and springs . All wound in and trued up. I think the ball may have been initially disturbed as we now have a better operating arm position.
It's still quite heavy but I'm going to try and back the springs off a shade. They're at the correct starting point , ie ,just at the thread in the screwdriver slot.