G2 clutch friction plate thickness

Information relating to the Matchless G2 or AJS Model 14 250cc Lightweight
Member
Posts: 113
Joined: Sun Jan 27, 2019 8:52 pm
Location: Dorset

G2 clutch friction plate thickness

Postby Richard Hyatt » Fri Jun 14, 2019 8:17 pm

Hi all,
we have been looking at the clutch on the G2 and it seems to slip a shade when starting but not under power on the road. I tease it over tdc and then I'm fine.
all adjustments at pushrod and clutch centre screw done and free play on cable etc.
springs wound up the the end of the thread as per book but I have had to wind them in a bit more to stand half a chance of starting it.

so I reckon it is time for 3 new friction plates as the others may be glazed or plain old and hard.

is there any particular thickness I need to look for please ??
while I am in there , I may do the clutch cush rubbers as well - any advice on these please

Return to G2 / Model 14

Who is online

Users browsing this forum: No registered users and 6 guests