Matchless G3L - Teledraulic Forks (Slider Extensions)
Posted: Sun Nov 04, 2018 6:44 pm
Greetings!
Working on the Teledraulics today and looks like the Slider Extensions are short of length. The previous owner just cut off a portion of it for reasons unknown.
I was wondering if I could make a replica of this as the design looks simple.
The question is
(1) Is this one complete part machined from a lathe
(2) Is this a 2 piece part, one being the hollow pipe and the other a threaded part, machined from a lathe and then welded together. Please advice
Also the threads on the fork legs are badly worn out. Can this be re-threaded?
Any advice will be extremely helpful.
Regards
PHenry
Working on the Teledraulics today and looks like the Slider Extensions are short of length. The previous owner just cut off a portion of it for reasons unknown.
I was wondering if I could make a replica of this as the design looks simple.
The question is
(1) Is this one complete part machined from a lathe
(2) Is this a 2 piece part, one being the hollow pipe and the other a threaded part, machined from a lathe and then welded together. Please advice
Also the threads on the fork legs are badly worn out. Can this be re-threaded?
Any advice will be extremely helpful.
Regards
PHenry