Page 1 of 1
g2 oil change
Posted: Thu Jul 05, 2018 8:23 pm
by dunsweepin
1966 g2 csr,changing engine oil and cleaning filter.i have fibre washers on both drain plugs is this correct ?
Re: g2 oil change
Posted: Thu Jul 05, 2018 9:48 pm
by ChrisTheChippy
Hi ,
As far as I'm aware that is correct as I have fibre washers on both drain plugs on my matchless G2 plus fibre washer on oil filter . Hope that helps.
Regards Chris
Re: g2 oil change
Posted: Fri Jul 06, 2018 7:43 am
by dunsweepin
cheers chris for that although my oil filter has a copper washer.i suppose if it seals its ok to use either ,dave
Re: g2 oil change
Posted: Sat Jul 07, 2018 6:19 pm
by dunsweepin
cheers for both replys lads,there is also a recess at the base of one drain plug,should it have an o ring fitted.
Re: g2 oil change
Posted: Sat Jul 07, 2018 7:46 pm
by Ozmadman
dunsweepin wrote:cheers for both replys lads,there is also a recess at the base of one drain plug,should it have an o ring fitted.
No o ring is fitted. Just a fibre Washer that is a sloppy fit as the thread is wider than the part of the plug where the was washer goes
Re: g2 oil change
Posted: Sun Jul 08, 2018 8:10 am
by dunsweepin
cheers oz,i am learning a little more every day