AMC gearbox kickstart shaft

General purpose topics/chat goes in here
Member
User avatar
Posts: 321
Joined: Fri Oct 15, 2004 12:00 am
Location: HESSEN GERMANY

AMC gearbox kickstart shaft

Postby PGGuse » Thu Jun 14, 2018 9:16 am

What is the best method to remove the bronze bushing off the kickstart shaft 040477?
Paul in Frankfurt
Last edited by PGGuse on Thu Jun 14, 2018 12:53 pm, edited 1 time in total.

Member
Posts: 201
Joined: Mon Jan 01, 1990 12:00 am
Location: GWENT UK

Re: AMC gearbox

Postby LynP » Thu Jun 14, 2018 11:14 am

Hi, the recommended method to remove the bronze bush from inside the kickstart shaft is to use a large tap to screw down the bush until it reaches the bottom of the hole and to keep turning until it pushes the shaft out. Maybe there are other methods that another member can suggest. Hope this helps.

Member
User avatar
Posts: 713
Joined: Thu Nov 12, 2015 2:22 pm
Location: Florida, USA

Re: AMC gearbox kickstart shaft

Postby Expat » Thu Jun 14, 2018 7:41 pm

Hello,
I replaced the gear shift bush by heating the cover evenly in an oven, screwing a tap into the bush, then turning the cover over and striking the end of the tap with a drift using a hammer.

Think if you try to use the tap to force the bush out backwards, you may damage the cover.

Cheers :)


Oops, just re read the question......seems I got the wrong end of the stick (or shaft).

Sorry. :oops:
Keep shiny side up.

Member
User avatar
Posts: 1248
Joined: Thu Jul 10, 2003 12:00 am
Location: HAMPSHIRE UK

Re: AMC gearbox kickstart shaft

Postby Duncan » Thu Jun 14, 2018 8:59 pm

Not necessarily the best method, but I put a 2 saw cuts in mine with the end of a hacksaw blade to loosen it and pulled it out. There is probably a dremel tool bit that would make the cut.

Return to General Topics

Who is online

Users browsing this forum: 56G80S and 17 guests