Pushrod tube washers
- Pharisee
- Member
- Posts: 1131
- Joined: Tue Mar 15, 2016 8:51 pm
- Location: Lincolnshire UK
- Contact:
Pushrod tube washers
When I took the head off my M18, I noticed that the dished washers that fit over the pushrod tube at the lower end of the sealing rubber had been put in different ways. One had the dished side down, the other had the dished side up. Logic would suggest that they should be fitted dished side down to match the tube but I thought I'd just check with you guys. I had a look in F. Neil's book but he merely says that there are metal washers each side of the sealing rubber; nothing about which way up they should be.
I'm from the Fens.... Gimme six.
-
- Posts: 2884
- Joined: Mon Mar 24, 2014 5:44 pm
- Location: Aberdeenshire
Re: Pushrod tube washers
Hi
Dished side down in order to push the seal against the bores in the head.
Regards Mick
Dished side down in order to push the seal against the bores in the head.
Regards Mick
-
- Member
- Posts: 8567
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: Pushrod tube washers
From Service Notes, by our old pal ITMA...... http://archives.jampot.dk/technical/Spe ... hanics.pdf
You do not have the required permissions to view the files attached to this post.
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'