Crashbar Securing Stud.
Posted: Mon Nov 13, 2017 6:49 pm
I recently purchased a crashbar.This is the single bar which attaches to the frame via the sidecar lug. A threaded stud approximately four inches long screws into the two halves where it protrudes from the lug.The stud I have is much too short.
I am unable to identify the correct stud required other than it is fourteen TPI,5/8" diameter but does not identify closely with any measurements I have taken with a caliper and compared the measurements with information on line to identify the correct thread.
Any information would be gratefully received.
I am unable to identify the correct stud required other than it is fourteen TPI,5/8" diameter but does not identify closely with any measurements I have taken with a caliper and compared the measurements with information on line to identify the correct thread.
Any information would be gratefully received.