Page 2 of 2
Re: Getting my 56 M30 go faster.
Posted: Fri Jul 28, 2017 5:06 pm
by raffles
If you want to gear up just increase the final drive sprocket. Burman not available from the club, but are from Draganfly Motors
who speacialise in Ariel parts
Tony
Re: Getting my 56 M30 go faster.
Posted: Fri Jul 28, 2017 5:15 pm
by ajscomboman
Up the gearbox sprocket to 17th. Club stock them, I've done the same to a 55 500cc Mod 20 as I found the original 16th sprocket too buzzy.
Re: Getting my 56 M30 go faster.
Posted: Fri Jul 28, 2017 6:51 pm
by G15 Roy
I did the same on my G11 special before the trip to Poland this year but made sure that the dynamo was in tip top condition for the increase speed and the bearings were good.
Re: Getting my 56 M30 go faster.
Posted: Fri Jul 28, 2017 7:37 pm
by ajscomboman
G15 Roy wrote:I did the same on my G11 special before the trip to Poland this year but made sure that the dynamo was in tip top condition for the increase speed and the bearings were good.
Oh ha ha very funny! The dynamo has been fine for 1000's miles it was just one of those things. I can't be blamed for a worn sealed bearing.
Re: Getting my 56 M30 go faster.
Posted: Fri Jul 28, 2017 8:01 pm
by G15 Roy
So as Les W would say blame the PO.
Re: Getting my 56 M30 go faster.
Posted: Fri Jul 28, 2017 9:00 pm
by leswaller
G15 Roy wrote:So as Les W would say blame the PO.
If the cap fits then wear it
