Page 1 of 1
Exhaust stud and nut size???
Posted: Sun Jul 24, 2016 9:39 pm
by sarkrob84
Hi I have a regal raptor dd125e-8 2009 does any one
Know the size of the stud and nut for the exhaust
Apparently their m6 36mm long but mine look more like
M8 nuts. Any help would be great. Thanks
Re: Exhaust stud and nut size???
Posted: Sat Jul 30, 2016 12:51 pm
by SPRIDDLER
Welcome, Robert.
Can't help directly I'm afraid, and few of us have Chinese AJS, but since no-one seems to have the answer the simplest solution is to buy an M6 and an M8 nut from Wickes or B&Q and try it for fit on the stud.
Can you not tell the nut size from a spanner that fits it?
There is a Haynes manual for Chinese bikes but I doubt that it'll give nut sizes...
https://haynes.co.uk/catalog/manuals-on ... -trackstar
Re: Exhaust stud and nut size???
Posted: Sun Jul 31, 2016 10:30 am
by Cerberus
You could always give AJS down at Andover a quick bell, they're were very helpful when I had to replace the drive side oil seal on an ECO-2.