Page 2 of 2
Re: Screw controlling oil feed to the inlet-valve stem
Posted: Sun Mar 03, 2019 10:48 pm
by Group Leader
I tried my mini adjustable but unfortunately there's not enough clearance around the nut. Needs a nice little ring spanner
Re: Screw controlling oil feed to the inlet-valve stem
Posted: Sun Mar 03, 2019 11:24 pm
by Rob Harknett
The nut is quite thin and often found damaged, never seems too difficult to loosen. Perhaps clean up the nut a bit, find an odd smaller spanner and open it out to a good fit, little flat cycle spanner may do. Only needs a little jerk to loosen , the remove complete clean up all, use hands only to replace with just a little nip of the lock nut with a spanner while holding the screw in place. Never found this part to be a problem.