Re: Centre stand question
Posted: Tue Jul 25, 2017 2:16 pm
TrevorB wrote:my prop stand doesn't have any lever to extend it with
AJS & Matchless Owners Club
AJS & Matchless Owners Club forum
https://forum.jampot.com/
Centre stand question
Page 3 of 3
Re: Centre stand question
Posted: Tue Jul 25, 2017 2:39 pm
Used a piece of 1/4 inch square section rod bent at right angle and fastened to stand leg with two jubbly clips.
Some black paint and job done
Some black paint and job done
Re: Centre stand question
Posted: Tue Jul 25, 2017 4:49 pm
I took the side stand off, heated it to red with a propane torch and bent it out a little. Not enough to appreciably change the lean angle but just enough for me to flip it out with my toe while I'm sitting on the bike.
Re: Centre stand question
Posted: Wed May 20, 2020 9:41 am
Hello G80 owners - is there a photo anywhere of the CENTRE STAND SPRING in the correct position? I have got my spring wound up with Jubilee clips, but am not sure which way it goes. Any photo please?
Re: Centre stand question
Posted: Wed May 20, 2020 10:29 am
Hi
This photo shows the correct orientation:
The small hook locates in the RH engine plate:
Regards Mick
This photo shows the correct orientation:
The small hook locates in the RH engine plate:
Regards Mick
Re: Centre stand question
Posted: Wed May 20, 2020 11:44 am
Mick - thank you most helpful!