Hi all
i have a problum with the engin that when it is cold it will start with chocke on but as soon as you move of and have full throtel on it runs then when you come to a junction it will stall unless you have full troatel but when it is hot it over revs or just dies at junctions 2
What would you suggest i have tried cleaning the carb adjusting all the screw on the carb. if anyone can give me a suggestion 2 what they should be set at
2006 Engine Problum
- markm
- Posts: 34
- Joined: Sat Jul 21, 2012 9:03 pm
- Location: aberdeenshire UK
2006 Engine Problum
AJS Regal Raptor 125 DD E 2006
- NoodleHead
- Posts: 31
- Joined: Thu May 31, 2012 4:15 pm
- Location: UK
- Contact:
2006 Engine Problum
Thats a difficult one markm. On the face of it it sounds like a fuel/air mixture problem or air filter blocked. Settings can slightly change from bike to bike. What model bike is yours?
- NoodleHead
- Posts: 31
- Joined: Thu May 31, 2012 4:15 pm
- Location: UK
- Contact:
2006 Engine Problum
For some good info and solving most problems you can try Johnny Pag/Regal Raptor forum at: alternativecruisers.com. Spyder is the name of the bikes in US. They are the same as the regal raptor and are distributed by customiser Johnny Pag. AJS are the agent/distributer for Regal Raptor in UK.
- markm
- Posts: 34
- Joined: Sat Jul 21, 2012 9:03 pm
- Location: aberdeenshire UK
- NoodleHead
- Posts: 31
- Joined: Thu May 31, 2012 4:15 pm
- Location: UK
- Contact:
2006 Engine Problum
I'v got the DD125E-5 Eos model fitted with the 300cc engine. Carb settings are very similar to 125. Carb Air mixture screws screwed out one and half turns. Try also checking engine valve clearances 0.08mm inlet and 0.15mm exhaust.
- markm
- Posts: 34
- Joined: Sat Jul 21, 2012 9:03 pm
- Location: aberdeenshire UK
2006 Engine Problum
which screw is the air mixture and which is the fuel you have 1 on the side of the carb and the other one is under the carb (which you cant get to with out taking the carb of or using a drill size screw bit
Thanks
Thanks
AJS Regal Raptor 125 DD E 2006
- NoodleHead
- Posts: 31
- Joined: Thu May 31, 2012 4:15 pm
- Location: UK
- Contact:
2006 Engine Problum
one mixture slotted head screw on each carb. Under at the front. Short 75mm length screwdiver required. Turn screw in to seat it then out one and half turns.