AJS 31 : 1961
-
- Deceased
- Posts: 75
- Joined: Mon Jan 01, 1990 12:00 am
- Location: BEDFORDSHIRE UK
AJS 31 : 1961
Well done, greasemonkey62 - that looks fine.
- greasemonkey62
- Posts: 562
- Joined: Wed Jun 16, 2010 12:37 pm
- Location: SOUTH YORKSHIRE UK
AJS 31 : 1961
cheers, if you decide to try and you need any dimentions give me a shout , but it is fairly straightforward
-
- Deceased
- Posts: 75
- Joined: Mon Jan 01, 1990 12:00 am
- Location: BEDFORDSHIRE UK
AJS 31 : 1961
Thanks, greasemonkey. Perhaps I will when I reach that stage - or when the weather gets warmer!
- greasemonkey62
- Posts: 562
- Joined: Wed Jun 16, 2010 12:37 pm
- Location: SOUTH YORKSHIRE UK
AJS 31 : 1961
note . when I bought the hydraulic pipe from the suppliers I bought it in 2 lengths and added 6 to 8 inches to each length as I asked them to put a 90 degree bend in the end of each length and they cannot bend too near the end so you have to allow for a little wastage for a perfect curve.
-
- Deceased
- Posts: 75
- Joined: Mon Jan 01, 1990 12:00 am
- Location: BEDFORDSHIRE UK
AJS 31 : 1961
Noted, thanks. My fabricator will probably use m.s. tube - at least, that's his intention.
-
- Posts: 328
- Joined: Sat Nov 26, 2011 12:07 pm
- Location: CHESHIRE UK
AJS 31 : 1961
Just to follow on re CSR style racks.
Andrews engineering apparently only ever made 1 as a one off for a customer. He said he might make one for me but not to hold my breath as they are very busy doing routine stuff
On doing some further research, sales@renntec.co.uk do one for a Bonny that might fit. I have emailed them for some dimensions etc.
Will report back...
~~~~~~~~~~~~~~~~~~~~~~~~~~~
John, with a G12, near Chester in the UK
John, with a G12, near Chester in the UK