Hi guys been a while as I've been trying to source more parts for my project and I've done a lot of searching on here and google but I'm getting myself a bit confused.
So I picked up a rear wheel with sprocket and bearings but no spindle, spacers or brake plate on inspection I found it has bearings that are not part of the hollow tube (each side is separate as shown in the 1950 parts list) are these just for the sprung back end or were they also fitted to the 1950 rigid? (I think the rear frame is 1950 after doing some research as both forks have the same gap 3/4", is that correct?) also these bearings take a 5/8" spindle but I thought I read somewhere the rigid should be 1/2" any help would be greatly appreciated and also is there an exploded diagram of all the spacers etc anywhere.
Cheers
- New Users
- Board index Help G80 / Model 18
-
- It is currently Thu May 16, 2024 6:47 pm
- All times are UTC+01:00
1950? Rear wheel
Information relating to the Matchless G80 or AJS Model 18 500cc Heavyweight.
-
- Member
- Posts: 388
- Joined: Tue May 25, 2021 10:50 pm
- Location: Oxfordshire UK
Jump to
- Public Forums
- ↳ General Topics
- ↳ Modern AJS
- ↳ Help
- ↳ Frequent Questions
- ↳ Recommendations
- ↳ Where are they now?
- ↳ News Items
- Help
- ↳ G2 / Model 14
- ↳ G3 / Model 16
- ↳ G5 / Model 8
- ↳ G80 / Model 18
- ↳ G80 Harris
- ↳ G9 / AJS Model 20
- ↳ G11 / AJS Model 30
- ↳ G12 / AJS Model 31
- ↳ G15 / AJS Model 33
- ↳ Competition / Racers
- ↳ Prewar
- ↳ Two Strokes
- ↳ Pre-War
- ↳ Post-War Classic
- ↳ G2 / Model 14
- ↳ G3 / Model 16
- ↳ G5 / Model 8
- ↳ G80 / Model 18 / Harris
- ↳ G9 / Model 20
- ↳ G11 / Model 30
- ↳ G12 / Model 31
- ↳ G15 / Model 33
- ↳ Modern AJS
- Sections
- ↳ Bristol
- ↳ Cheshire and North Wales
- ↳ Chiltern
- ↳ East Berkshire
- ↳ East London and Essex
- ↳ East Midlands
- ↳ East Suffolk
- ↳ East Yorkshire
- ↳ Fenrunners
- ↳ Hampshire
- ↳ Heart of England
- ↳ Kent
- ↳ North East
- ↳ Notts and Derby
- ↳ Oxford
- ↳ Poachers
- ↳ Surrey
- ↳ Sussex
- ↳ Wey Valley
- ↳ Worcester
- ↳ France