Kickstart shaft '64 AMC box
-
- Member
- Posts: 194
- Joined: Wed Aug 19, 2020 11:22 am
- Location: Dorset UK
Kickstart shaft '64 AMC box
Discovered that the kickstart shafts are different, the 'new' one has the spring hole in a different place than the old one, I am assuming that the 'new' one is the earlier type? Will the Norton 06.6169 shaft will replace the old one?
You do not have the required permissions to view the files attached to this post.
- Joker_Bones
- Member
- Posts: 552
- Joined: Sat Apr 27, 2013 3:51 pm
- Location: DORSET UK
Re: Kickstart shaft '64 AMC box
I'm not quite sure what you are asking...
Here are a couple of pics of the shafts fitted to the earlier (M) and later (MA) type boxes, if it helps. The later box is the one with the gasket fitted. The boss the spring is on in the case is reduced, the return spring is longer.
Here are a couple of pics of the shafts fitted to the earlier (M) and later (MA) type boxes, if it helps. The later box is the one with the gasket fitted. The boss the spring is on in the case is reduced, the return spring is longer.
You do not have the required permissions to view the files attached to this post.
-
- Member
- Posts: 194
- Joined: Wed Aug 19, 2020 11:22 am
- Location: Dorset UK
Re: Kickstart shaft '64 AMC box
Thanks for the pictures, illustrates the issue nicely, I did not know there are two flavours of bulkhead plates so I learned something today. I managed to get a new shaft that has both holes in so one size fits all which is handy.