Hi
Can anyone help me with this?
It's probably very easy but i can't figure ir out how to align the push-pull fuel taps?
I have each one poitting to each Direction
Thanks
Fuel taps push-pull alinment
-
- Member
- Posts: 2
- Joined: Wed Oct 26, 2022 12:14 am
- Location: Lisbon District PORTUGAL
-
- Member
- Posts: 8574
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: Fuel taps push-pull alinment
Welcome to the Forums, Sergio.
You could add another fibre washer, maybe two washers, so that each tap tightens up earlier and aligns as you want it.
You could add another fibre washer, maybe two washers, so that each tap tightens up earlier and aligns as you want it.
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'
-
- Member
- Posts: 222
- Joined: Wed Nov 18, 2015 7:43 am
- Location: wiltshire
- Location: near swindon wilts
Re: Fuel taps push-pull alinment
get some loctite 577 and put it on threads and fibre washer and then do tap up to where you want it to sit and it should stay there once the loctite pipe thread sealant is cured .
ian
ian
-
- Member
- Posts: 231
- Joined: Fri Dec 31, 2010 10:02 am
- Location: South Australia AUSTRALIA
Re: Fuel taps push-pull alinment
Another method is to use the thread tape plumbers use (it is petrol proof) allows the tap to tighten to the spot you require. Helps with sloppy old threads prone to weeping.
-
- Member
- Posts: 2
- Joined: Wed Oct 26, 2022 12:14 am
- Location: Lisbon District PORTUGAL
Re: Fuel taps push-pull alinment
Thanks
I used i mixed off the methods and worked perfect
Thanks for your Replay
I used i mixed off the methods and worked perfect
Thanks for your Replay