Help again please.
1960G12.
Two frame attachment positions are obvious, top and rear side (brackets are part of frame).
Is there another attachment point, forward and bottom, or anywhere else. If so do I need a loose bracket of some sort to attach to where on the frame. Apologies for the banal questions, serves me right for not taking photographs as I stripped it down some time ago.
JohnT
Toolbox attachment
-
- Posts: 136
- Joined: Wed May 08, 2019 7:41 pm
- Location: UK
Toolbox attachment
JohnT
-
- Posts: 128
- Joined: Fri Oct 29, 2010 12:03 pm
- Location: CO. GALWAY EIRE
Re: Toolbox attachment
Those are the only two attachment points on mine . I don't think you are missing anything.
-
- Posts: 2886
- Joined: Mon Mar 24, 2014 5:44 pm
- Location: Aberdeenshire
Re: Toolbox attachment
Hi
On my 61 G3 there is a 'Z' shaped bracket lower front:
Part number 026353 and is valid for all non competition models - see pg 48 of the 60 parts manual.
(Photo shows it during a trial fit of the toolbox, the bracket is bolted to the tool box and the upper engine plate stud).
Regards Mick
On my 61 G3 there is a 'Z' shaped bracket lower front:
Part number 026353 and is valid for all non competition models - see pg 48 of the 60 parts manual.
(Photo shows it during a trial fit of the toolbox, the bracket is bolted to the tool box and the upper engine plate stud).
Regards Mick
You do not have the required permissions to view the files attached to this post.
-
- Posts: 136
- Joined: Wed May 08, 2019 7:41 pm
- Location: UK
Re: Toolbox attachment
MickD,
That's what I was looking for, I think without that bracket vibration would fracture the other two attachments.
Thank you JohnT
That's what I was looking for, I think without that bracket vibration would fracture the other two attachments.
Thank you JohnT
JohnT
-
- Posts: 128
- Joined: Fri Oct 29, 2010 12:03 pm
- Location: CO. GALWAY EIRE
Re: Toolbox attachment
Sorry if I misled you John.
Both my machines are missing this bracket so I assumed only two fixings were normal
regards
Gerard
Both my machines are missing this bracket so I assumed only two fixings were normal
regards
Gerard
-
- Posts: 136
- Joined: Wed May 08, 2019 7:41 pm
- Location: UK
Re: Toolbox attachment
That's ok I copied MickD's,gotoole wrote:Sorry if I misled you John.
Both my machines are missing this bracket so I assumed only two fixings were normal
regards
Gerard
You do not have the required permissions to view the files attached to this post.
JohnT