So if didn't quite go as planned. The painters put epoxy primer on the frame number. It is still visible though.asterysk_usa wrote:I now have a very clear frame number after blasting, have asked the paint shop to mask the frame number before they powder coat with epoxy primer . This then leaves me with the decision on what to do with the bare metal around the frame number so that I prevent rust but keep the stamping very clear, open to any suggestions
Problem is going to be when the top coat goes on , the stamping will be difficult to see.
Do you think I can apply lacquer directly to the epoxy primer in the area of the frame number ?
Sent from my iPhone using Tapatalk