Jampot Outer Tube - Too Far Gone? (1955 18CS)
16 posts
• Page 2 of 2 • 1, 2
- spookefoote1956
- Member
-
- Posts: 879
- Joined: Mon May 01, 2017 6:32 pm
- Location: Lancashire
Re: Jampot Outer Tube - Too Far Gone? (1955 18CS)
Will Girling units fit? If so I'd get some "new" ones off fleabay. Depends on how concerned you are with originality. Got mine £129.99.
हरे कृष्ण हरे कृष्ण
Hail Joe Lucas ............ Prince of Darkness!
All my bikes are original........ to me!
Hail Joe Lucas ............ Prince of Darkness!
All my bikes are original........ to me!
Re: Jampot Outer Tube - Too Far Gone? (1955 18CS)
I recall A M C Classic spares listing inserts for jampots.
Re: Jampot Outer Tube - Too Far Gone? (1955 18CS)
The inserts are made by Icon https://ikonshocks.co.uk/product-category/ajs/ajs-jam-pot-conversion/
Re: Jampot Outer Tube - Too Far Gone? (1955 18CS)
Hi
That damage looks like 'pick up' from being ridden without oil in the unit - in view of the cost of replacement internals
I'd check the units slide reasonably easily with no pronounced tight spots and rebuild filling with heavier grade oil - its not a road racer
Regards Mick
That damage looks like 'pick up' from being ridden without oil in the unit - in view of the cost of replacement internals


Regards Mick
- spookefoote1956
- Member
-
- Posts: 879
- Joined: Mon May 01, 2017 6:32 pm
- Location: Lancashire
Re: Jampot Outer Tube - Too Far Gone? (1955 18CS)
Duncan wrote:The inserts are made by Icon https://ikonshocks.co.uk/product-category/ajs/ajs-jam-pot-conversion/
£301.67 Ouch


हरे कृष्ण हरे कृष्ण
Hail Joe Lucas ............ Prince of Darkness!
All my bikes are original........ to me!
Hail Joe Lucas ............ Prince of Darkness!
All my bikes are original........ to me!
Re: Jampot Outer Tube - Too Far Gone? (1955 18CS)
Ikons are the brand I used, but then I saw a cheaper version similar to a girling design I think these are stocked by A M C Classic spares. N J B Shocks, Colchester, do a range of girling type classic shocks
The company owner is a ex girling engineer.
The company owner is a ex girling engineer.
16 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 6 guests