Hi all , bike is G2 1961.
We've recently bought a new pipe and silencer from armours. Beautiful chrome.
But the question is the depth of penetration of the pipe into the silencer when assembled.
It seems to go on and on before all fixing points line up and off hand I'd say 9 inches or so.
Is this correct depth please ? Usually they only just slip on for a couple of inches then clamp up.
Thank you
Exhaust pipe to silencer depth
-
- Posts: 113
- Joined: Sun Jan 27, 2019 8:52 pm
- Location: Dorset
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Exhaust pipe to silencer depth
Don't worry about it, be fine, what I will say is Frankie Howard would have a field day reading that post
Colin
Colin
only dead fish go with the flow
-
- Posts: 113
- Joined: Sun Jan 27, 2019 8:52 pm
- Location: Dorset
Re: Exhaust pipe to silencer depth
Ha
I know , but I couldn't think of other words to use to ask the question!!!!!!!!
I know , but I couldn't think of other words to use to ask the question!!!!!!!!
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
Re: Exhaust pipe to silencer depth
Must admit it doesn't sound right to me - you'd think that half of the silencer is being bypassed - would it be quieter if the downpipe was shorter?
-
- Posts: 113
- Joined: Sun Jan 27, 2019 8:52 pm
- Location: Dorset
Re: Exhaust pipe to silencer depth
This is what I'm wondering ?
I need to remove the silencer and measure the depth of the first baffle. For all I know the exhaust gas is getting held back or strangled.
I need to remove the silencer and measure the depth of the first baffle. For all I know the exhaust gas is getting held back or strangled.
-
- Member
- Posts: 609
- Joined: Mon Jan 01, 1990 12:00 am
- Location: NORTHAMPTONSHIRE UK
Re: Exhaust pipe to silencer depth
You will not find a baffle. originally the pipe extended into the silencer and had the end sealed and slots
cut into the pipe, thus reducing the noise these days what you get is a straight through system, feel free
to block the pipe and cut slots if you wish. It will take the edge off of the noise but over done can also
take the edge off of the performance.
Tony
cut into the pipe, thus reducing the noise these days what you get is a straight through system, feel free
to block the pipe and cut slots if you wish. It will take the edge off of the noise but over done can also
take the edge off of the performance.
Tony
-
- Posts: 113
- Joined: Sun Jan 27, 2019 8:52 pm
- Location: Dorset
Re: Exhaust pipe to silencer depth
That's a really good idea to revert to original.
I can weld a plate over the end and angle grind a series of slots in the end few inches.
It has a real crack from this new exhaust , nice but a shade antisocial
I can weld a plate over the end and angle grind a series of slots in the end few inches.
It has a real crack from this new exhaust , nice but a shade antisocial