gear lever question
- GOLDSTAR
- Member
- Posts: 2521
- Joined: Thu Sep 11, 2003 1:00 am
- Location: KENT UK
gear lever question
can anyone tell me if the gear lever for a CP box is the same as for a GB box pse? kind regards
- dave16mct
- Member
- Posts: 3246
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: gear lever question
No, the CP has a bigger splined hole than the B52.
Dave.
Dave.
- Rob Harknett
- Member
- Posts: 11211
- Joined: Mon Jan 01, 1990 12:00 am
- Location: ESSEX UK
Re: gear lever question
Quite different in appearance, check archive parts lists. Burman never changed pt. no's. as AMC did circa 1952
You do not have the required permissions to view the files attached to this post.
- GOLDSTAR
- Member
- Posts: 2521
- Joined: Thu Sep 11, 2003 1:00 am
- Location: KENT UK
Re: gear lever question
thanks guys, I need a steel one for a CP that I can bend to lower the front as I have to raise my foot off the peg to change down, I cannot adjust the peg unfortunately, the g/box is in a, dare I say it? O.K whisper then ariel w/ng. kind regards
- Rob Harknett
- Member
- Posts: 11211
- Joined: Mon Jan 01, 1990 12:00 am
- Location: ESSEX UK
Re: gear lever question
Bit puzzled why you need to raise your foot. I had small size 7 now 8 feet never had to raise my foot on any bike. Have you the wrong footrest or it needs adjusting.?
-
- Member
- Posts: 452
- Joined: Tue May 27, 2003 1:00 am
- Location: SHROPSHIRE UK
Re: gear lever question
Can you not adjust it on the splines
- GOLDSTAR
- Member
- Posts: 2521
- Joined: Thu Sep 11, 2003 1:00 am
- Location: KENT UK
Re: gear lever question
no it fouls the footrest if I lower it, I guess it was so for the damn great squaddie boots worn at the time, and I 'spect a bit of wear in the selectors. Kind regards
- Rob Harknett
- Member
- Posts: 11211
- Joined: Mon Jan 01, 1990 12:00 am
- Location: ESSEX UK
Re: gear lever question
Study these two pictures side by side, you may spot why you have a problem. One pic is 1946 the other 1952
You do not have the required permissions to view the files attached to this post.
- GOLDSTAR
- Member
- Posts: 2521
- Joined: Thu Sep 11, 2003 1:00 am
- Location: KENT UK
Re: gear lever question
the box is different to both you show Rob, it has an external operating pushrod lever as well. kind regards