Hi
I wish to lengthen an existing clutch cable as there is not quite enough adjustment available, to do this I intend to retain all of the fittings and the outer, (which has specific end fittings swaged on), and fit a longer inner. The existing inner is a 19 strand single bunch cable with a diameter of 2.25mm, (possibly 3/32"). I've been in touch with Venhill but they don't supply this size. Does anyone have any ideas of where else I could try? The internet doesn't seem to be throwing up much in the way of options, (or I'm using the incorrect terms).
Regards Mick
Wire Cable Supplier
-
- Posts: 2884
- Joined: Mon Mar 24, 2014 5:44 pm
- Location: Aberdeenshire
- dave16mct
- Member
- Posts: 3245
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LANCASHIRE UK
Re: Wire Cable Supplier
Vehicle Wiring Products do 2.25mm 19 strand at 0.98p per metre.
Cheers Dave
Cheers Dave
-
- Posts: 2884
- Joined: Mon Mar 24, 2014 5:44 pm
- Location: Aberdeenshire
Re: Wire Cable Supplier
Thanks Dave
Didn't think of looking there
Just got off the phone to JJ Cables who can also supply, (at a much better rate )
Regards Mick
Didn't think of looking there
Just got off the phone to JJ Cables who can also supply, (at a much better rate )
Regards Mick
-
- Member
- Posts: 1580
- Joined: Mon Jan 01, 1990 12:00 am
- Location: WEST SUSSEX UK
Re: Wire Cable Supplier
Its much easier and stronger to cut the outer if its long enough and push the end back on . you can do this without removing the nipple using dremel etc and winding the cut outer off the cable