The hole in the top end is not completely open the gudgeon pin runs through the bush ok but the small end bush seems to have moved slightly at sometime and covered about a third of the hole.
Do I redrill??
Small end bush
-
- Member
- Posts: 1102
- Joined: Tue Jan 15, 2008 4:18 pm
- Location: SOMERSET UK
Small end bush
Mike
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Small end bush
Hi Mike,
If the bush is central in the con rod I would re-drill very gently or if off centre maybe needs a push in the right direction
Colin
If the bush is central in the con rod I would re-drill very gently or if off centre maybe needs a push in the right direction
Colin
only dead fish go with the flow
-
- Member
- Posts: 1102
- Joined: Tue Jan 15, 2008 4:18 pm
- Location: SOMERSET UK
Re: Small end bush
Thanks Colin, reassurance is a splendid thing, all done and piston fitted, feels like a bit of fine scraping going on (rings bedding in?) but no scratching of bore, so good to go.
Thanks again.
Thanks again.
Mike