Threads in forks
7 posts
• Page 1 of 1
Threads in forks
The India made mudguards are coming along nicely so far. But the bolts holding the front mudguard stays to the bottom of the fork sliders were too small and held in place with nuts. The threads in the forks look good so I'd like to do a proper job. So I need to get new bolts. Can anyone tell me what the thread form would be for a 1957 18s
Thanks in advance Harry
Thanks in advance Harry
si is does non opportunus vos postulo a maior pango
Re: Threads in forks
Thanks Dave. Ebay here I come
si is does non opportunus vos postulo a maior pango
Re: Threads in forks
56G80S wrote:Don't the Club or AMC Clasics have them?
Johnny B
I expect so and I use the club spares as much as I can, but the postage for two bolts is a bit too much.
si is does non opportunus vos postulo a maior pango
Re: Threads in forks
But will you be able to buy the correct bolts?they are 5/16 bsf but with a 3/16 whit head not 1/4.
Tony
Tony
Re: Threads in forks
raffles wrote:But will you be able to buy the correct bolts?they are 5/16 bsf but with a 3/16 whit head not 1/4.
Tony
Oops that'll upset the rivet counters

The bolts I'm using are longer than standard so that I can put locknuts on 'tother end
si is does non opportunus vos postulo a maior pango
7 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests