loose kick start
- 27col
- Posts: 42
- Joined: Fri Jan 01, 1999 12:00 am
- Location: HAMPSHIRE UK
loose kick start
The kick start on my AJS model 31 keeps on working loose. I have fitted it with a high tensile clamping bolt, but it is still working loose and damaging the splines. Has anybody come across this problem and , more to the point, can anybody suggest a solution. I drilled and tapped into the end of the splined shaft so as to be able to fit a retaining washer. This at least, stops the kickstart from coming too far off the splines but does not help the original problem.
-
- Posts: 15
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: UK
loose kick start
I had this problem on a commando ( similar gearbox) it was caused by the diameter of the retaining bolt being too small.....ie. in relation to the kickstart shaft. i bored out the kickstart hole slightly and fitted an oversize bolt with the same thread configuration....result, no lateral movement end of problem.
- 27col
- Posts: 42
- Joined: Fri Jan 01, 1999 12:00 am
- Location: HAMPSHIRE UK
loose kick start
To John Turnbull, Many thanks to you for your suggestion. I had come to more or less the same conclusion myself. I will put it on the list for attention during next winter's lay-up.
- 27col
- Posts: 42
- Joined: Fri Jan 01, 1999 12:00 am
- Location: HAMPSHIRE UK
loose kick start
To John Turnbull.
I don't suppose that you remember the diameter that you used, do you?
I don't suppose that you remember the diameter that you used, do you?