OK...took some time off from this project. Had to wait for some parts, among other things. Started to work on it again.
Started by disassembling the clutch. Found that 2 of the friction plates were stuck to 2 of the steel plates. Had to pry them apart with a screwdriver. there was some rust buildup on them but seemed to clean off ok. Reassembling was more difficult than I thought it would be. With the clutch centre on the bike I couldn't get the sprocket over the roller cage. I ended up taking off the back plate from clutch centre, put roller on the sprocket then reassemble everything. This took several attempts as you need more than 2 hands to do this
Now I've got the clutch assembly back on the bike.
My next question is....how do you install the rubber shock absorbers? I have the tool to turn the clutch hub but they don't seem to compress enough. The instruction book says to remove compress thick rubbers and take out thin rubbers first. REVERSE this to refit rubbers. Does this mean compress thin rubbers while installing thicker ones? I've tried both ways and can't get them in.
Wondering if there was a trick to this? Maybe heat up the rubbers to soften them? Just didn't want to use too much force on them.
Thanks