I hope someone can assist with my problem, which I thought would have been fairly simple, but have had no success with so far. I have the earlier centre bearing (011547) which has the integral thrust washers. This has proved impossible to locate so far.
Does anyone know a source for these bearings. I need a set of +30 or possibly +40, if the +30's are not available.
Any leads would be greatfully appreciated.
Thanks
Chris
1951 G9 centre web bearing
-
- Posts: 2
- Joined: Thu Mar 27, 2003 12:00 am
- Location: AUSTRALIA
- silverarrow
- Posts: 549
- Joined: Mon Jan 01, 1990 12:00 am
- Location: LEICESTERSHIRE UK
1951 G9 centre web bearing
I thought I had heard that these were now in stock in the spares scheme. contact Jim.
Les Smith
Les Smith
Keep smiling
- bjork
- Member
- Posts: 1907
- Joined: Wed Jan 01, 1997 12:00 am
- Location: LEICESTERSHIRE UK
- Location: Leicestershire
1951 G9 centre web bearing
I think Les is right,I did a twin not too long ago,and when I went to Kettering all the undersizes were in stock for mains and big ends.I'm doing another one now and as soon as I know what undersize the crank is to be ground, to I'll be straight back there.You did check the club scheme didn't you Chris?
Using yesterdays technology to create tomorrows problems today
-
- Posts: 2
- Joined: Thu Mar 27, 2003 12:00 am
- Location: AUSTRALIA
1951 G9 centre web bearing
Thanks Les and Steve.
I must admit, I didn't check with the spares scheme, as they did not have them listed. I probably assumed too much. Will check with them first in future!
Thanks again
Chris
I must admit, I didn't check with the spares scheme, as they did not have them listed. I probably assumed too much. Will check with them first in future!
Thanks again
Chris