Definitive 1950 G9 Bottom end...
-
- Posts: 52
- Joined: Fri Jan 04, 2019 6:05 am
- Location: Sth.Aus.
Re: Definitive 1950 G9 Bottom end...
...
Last edited by matg80s on Sun Apr 07, 2019 10:27 am, edited 1 time in total.
-
- Member
- Posts: 1176
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: KENT UK
Re: Definitive 1950 G9 Bottom end...
Check for out of roundness of the big end of the con rods. they need to be round before you fit the shells. most go out of round( a few thou) in use. Best to sort that out soon. I got told that by the firm that did my crankshaft regrind and they know a lot about AMC engine stuff. T& l engineering, advertise in the club mag.
Best of luck with your rebuild. Make sure you get the centre web the right way round
Best of luck with your rebuild. Make sure you get the centre web the right way round
-
- Posts: 52
- Joined: Fri Jan 04, 2019 6:05 am
- Location: Sth.Aus.
Re: Definitive 1950 G9 Bottom end...
...
Last edited by matg80s on Sun Apr 07, 2019 10:27 am, edited 1 time in total.
-
- Posts: 52
- Joined: Fri Jan 04, 2019 6:05 am
- Location: Sth.Aus.
Re: Definitive 1950 G9 Bottom end...
...
Last edited by matg80s on Sun Apr 07, 2019 10:28 am, edited 1 time in total.
-
- Posts: 52
- Joined: Fri Jan 04, 2019 6:05 am
- Location: Sth.Aus.