Hi
Here's a photo of my adjuster - should be the same as yours:
And here's a snag from the manual:
Available from the archive:
http://archives.jampot.dk/
Regards Mick
Hello from Oz.
-
- Posts: 2884
- Joined: Mon Mar 24, 2014 5:44 pm
- Location: Aberdeenshire
Re: Hello from Oz.
You do not have the required permissions to view the files attached to this post.
-
- Member
- Posts: 39
- Joined: Mon May 14, 2018 9:56 am
- Location: Queensland AUSTRALIA
Re: Hello from Oz.
Thank you Mick, you are a life saver. It looks to be stainless steel.
I had that illustrated pic but hard to fabricate something from that.
Thank you again.
I had that illustrated pic but hard to fabricate something from that.
Thank you again.
-
- Posts: 2884
- Joined: Mon Mar 24, 2014 5:44 pm
- Location: Aberdeenshire
Re: Hello from Oz.
Hi Allen
It's actually bright zinc plated steel I think, I'll get you the dimensions from the old one if I can find it.
Here you go:
Regards Mick
It's actually bright zinc plated steel I think, I'll get you the dimensions from the old one if I can find it.
Here you go:
Regards Mick
You do not have the required permissions to view the files attached to this post.
-
- Member
- Posts: 8559
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: Hello from Oz.
You don't need verification of the frame number, per se. I mentioned the Dating service as you wrote: <<I was checking out my frame # to see if it matched the 57/G80s stamped on the motor>>. Unlike some Brit bikes the AMC bikes didn't have 'matching' numbers i.e the same number on both engine and frame. I've twigged now that you meant you were checking that the engine and frame were the same year rather than the same number.Allen_F wrote:Not sure why I might need verification of frame year though, unless Department of transport require it for historical registration, if I go that rout.
The frame number is the key (in the factory records) that identifies how the bike was originally configured (DOM, marque, model, engine and g/box nos.) and to where it was shipped initially from the factory. Many folk with a new bike are curious as to the history of exactly what it was when it left the factory as bits get changed over the years.
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'
-
- Member
- Posts: 3367
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: N YORKS UK
Re: Hello from Oz.
Mick D's done a great job there and that mirrors what I have on my 1956 G80S - but it has an AMC gearbox swapped in for the Burman with the necessary change in the spacer ring on the driveshaft crank axle; which reminds me that I need to find the Burman one for when I put that in over winter to refurb the AMC - damn!
Johnny B
Johnny B
-
- Member
- Posts: 39
- Joined: Mon May 14, 2018 9:56 am
- Location: Queensland AUSTRALIA
Re: Hello from Oz.
Thank you all for your time and here is your reward.
You do not have the required permissions to view the files attached to this post.