sizes of rocker arm
-
- Posts: 264
- Joined: Sun Apr 30, 2017 10:42 pm
- Location: ARGYLL UK
Re: sizes of rocker arm
I see. Sorry got confused. If Sprids 1.5" valve side arm is standard, then 50% it is for "spriddlers Tiddler" - that seems too much of an increase to not cause problems - would you agree?
-
- Member
- Posts: 8558
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: sizes of rocker arm
I'd guess that a 50% increase in lift using 'my' 1" arm would likely to be too much and the piston would probably hit the open valve but you're welcome to try it. It's also possible that the '47 axle splines are oriented differently from your axle vis-Ã -vis lining up with the mating cut-outs in the arm. Maybe better to go for a L/W arm, eh?
No message rec'd............but if your message would be in the affirmative and you want to try the arm text your address to 07815 995548 and I'll post it on Monday...
.....Over.
No message rec'd............but if your message would be in the affirmative and you want to try the arm text your address to 07815 995548 and I'll post it on Monday...
.....Over.
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'
-
- Posts: 264
- Joined: Sun Apr 30, 2017 10:42 pm
- Location: ARGYLL UK
Re: sizes of rocker arm
"Calling Spriddler Calling Spriddlar this is Stephen G80. Agreed. Wilco L/W arm. Out"
Thanks for the offer though. That was quite a thread - we got there in the end. I'll stick with trying to source a G2 or G5 arm
Thanks for the offer though. That was quite a thread - we got there in the end. I'll stick with trying to source a G2 or G5 arm
-
- Member
- Posts: 610
- Joined: Mon Jan 01, 1990 12:00 am
- Location: NORTHAMPTONSHIRE UK
Re: sizes of rocker arm
Do you not think that as all of these threads were started from information that originated from Ken de Groome .That he would have worked out the best
way to go. So why not simply follow the Experts advice.
Tony
way to go. So why not simply follow the Experts advice.
Tony
-
- Member
- Posts: 8558
- Joined: Wed Sep 01, 2004 1:00 am
- Location: WEST SUSSEX UK
Re: sizes of rocker arm
Where's the fun in that? Common sense and being right is so BORING!raffles wrote:Do you not think that as all of these threads were started from information that originated from Ken de Groome .That he would have worked out the best way to go. So why not simply follow the Experts advice. Tony
(It reminds me of one of my wives ).
'There is a tide in the affairs of men
Which taken at the flood............'
Which taken at the flood............'
-
- Posts: 264
- Joined: Sun Apr 30, 2017 10:42 pm
- Location: ARGYLL UK
Re: sizes of rocker arm
I think you have missed the point Tony - we were following that and trying to ascertain how to identify a G2 or G5 arm out of situ. If you have definitive answer to that question then why not share it?raffles wrote:Do you not think that as all of these threads were started from information that originated from Ken de Groome .That he would have worked out the best
way to go. So why not simply follow the Experts advice.
Tony
Finally its been a bit of fun as well and surely that's what ts all about