clutch hub fouls inner chaincase

Information relating to the Matchless G80 or AJS Model 18 500cc Heavyweight.
Member
User avatar
Posts: 11
Joined: Sun Jun 09, 2019 7:40 pm
Location: Wiltshire UK

clutch hub fouls inner chaincase

Postby Stephen R » Wed Sep 11, 2019 12:36 pm

I'm reassembling an 18CS with the pressed steel primary chaincases, the back of the clutch hub ( the locknuts on the spring pins) rubs the chaincase inner. I cant pack the clutch out because that would rub on the gearbox output shaft, so what has hAppened/ do I need to shorten the spacer to bring the primary cases closer in to the engine and away from the cluch hub?



Steve

Member
Posts: 59
Joined: Mon Jan 01, 1990 12:00 am
Location: NORWAY

Re: clutch hub fouls inner chaincase

Postby bjorn » Wed Sep 11, 2019 9:55 pm

Hi Steve,
I believe it would be helpful if you gave some more info on the machine. From your description of the clutch it would be an AMC item? So 1957 model or later? Are the motor/gearbox/clutch all from the same year? Has it been previously assembled/running without the clutch to chaincase clearance problem?

regards
Bjørn

Member
User avatar
Posts: 2202
Joined: Mon Oct 05, 2009 12:00 am
Location: ESSEX UK

Re: clutch hub fouls inner chaincase

Postby 1608 » Thu Sep 12, 2019 2:32 pm

It could be the hub centre ( vanes ) wearing on the end and allowing the hub centre to chafe the inner chain case. This is normally due to the 60 yr old part being constantly tightened/over tightened causing the splines to wear. I had to renew mine because the hub centre had a groove worn on the end from contacting the gearbox input shaft. Hope that makes sense!

Return to G80 / Model 18

Who is online

Users browsing this forum: No registered users and 14 guests