Hi, I'm making up some stainless rear chain adjusters - as I don't have any to measure could someone tell me the spanner size for them.
Cheers
Chain adjuster spanner size
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Chain adjuster spanner size
It would have been .340" A/F which is 1/8 whit but you could use 8 or 9 mm or even 3/8" hex and don't forget to use reduced A/F locking nuts.
Colin
Colin
only dead fish go with the flow
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
Re: Chain adjuster spanner size
Thanks Colin - much appreciated.
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Chain adjuster spanner size
A good source for stainless bar including Whit hex is Noggin End Metals.
Colin
Colin
only dead fish go with the flow
- Martin.S
- Posts: 443
- Joined: Sun Mar 18, 2018 12:02 pm
- Location: Bristol UK
Re: Chain adjuster spanner size
And skips
- Peter Morris
- Member
- Posts: 733
- Joined: Wed Mar 05, 2014 4:21 pm
- Location: SURREY UK