G2 shock absorbers
16 posts
• Page 2 of 2 • 1, 2
Re: G2 shock absorbers
Ozmadman wrote:you will need to push down hard on the top shroud to release the two halves of the retaining ring that sits in the top, that's all and not too difficult reallyBernie.Jones wrote:Thanks - that looks like it could be a cheaper option if I can get them apart. Looks like the shrouds are available on eBay in a variety of sizes.
Cheers,
Bernie
Dont forget to turn the adjuster collar round to minimum to reduce the preload on the springs.
- Bernie.Jones
- Posts: 27
- Joined: Sun Oct 28, 2018 8:58 am
- Location: United Kingdom
Re: G2 shock absorbers
Thanks all, will give it a go.
Cheers,
Bernie
Cheers,
Bernie
Re: G2 shock absorbers
Hi
If you feel the need to make a spring compressor exhaust flanges and studding are a good place to start:
Regards Mick
If you feel the need to make a spring compressor exhaust flanges and studding are a good place to start:
Regards Mick
You do not have the required permissions to view the files attached to this post.
- Bernie.Jones
- Posts: 27
- Joined: Sun Oct 28, 2018 8:58 am
- Location: United Kingdom
Re: G2 shock absorbers
Great idea! Thanks Mick.
Re: G2 shock absorbers
For interest and by coincidence I've just seen this rather clever idea using a bath sealant 'gun', although I'm not sure if it work on your units........
https://youtu.be/eEQTYbVQLuw
https://youtu.be/eEQTYbVQLuw
I poke badgers with spoons.....from 2 metres.
- Bernie.Jones
- Posts: 27
- Joined: Sun Oct 28, 2018 8:58 am
- Location: United Kingdom
Re: G2 shock absorbers
Ingenious! I think we will have to find out.... will post back the results later today.
Many thanks,
Bernie
Many thanks,
Bernie
16 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 9 guests