Model 14
17 posts
• Page 2 of 2 • 1, 2
- ajscomboman
- Member
-
- Posts: 2680
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: Model 14
shifter wrote:I have snooped/asked around and will continue to do so at getting a batch made to no avail up to now. Unfortunately foundry's and the like are few and far up this end
Same down in the south, however the thought occurred that maybe more a hobbyist manufacturer may look at these, people that produce items in museums etc. I'll keep snooping as well.
Re: Model 14
Hi, I had the same problem in finding a good spline centre. For kickstart shaft. I purchased a similar sized new spline shaft off eBay but with straight shaft. Cut the new spline boss off and welded it to
My cranked origional kickstart shaft. Works fine.
My cranked origional kickstart shaft. Works fine.
Re: Model 14
I also had our local blacksmith weld the top from one kickstart with poor splines onto another with good splines.
It's been working a treat.
It was stick welding using a high chrome content rod.
Johnny B
It's been working a treat.
It was stick welding using a high chrome content rod.
Johnny B
Re: Model 14
I'm looking for a kickstarter for a G2, like mentioned very hard to get hold of, if someone could get them made I would be happy to pay upfront
Re: Model 14
Well that's the little model 14 finished it may not totally original or perfect but I'm pleased the way its turned out, its got a Cpl of testing run outs under its belt at the mo and I must say it performed very well.
shifter
shifter
Last edited by shifter on Fri Feb 15, 2019 12:39 am, edited 3 times in total.
?
Re: Model 14
shifter wrote:Well that's the little model 14 finished it may not totally original or perfect but I'm pleased the way its turned out, its got a Cpl of testing run outs under its belt at the mo and I must say it performed very well.
Nice one!!
Paul
1960 Model 8
1974 Yamaha RD250B US Model 6 speed
1960 Model 8
1974 Yamaha RD250B US Model 6 speed
Re: Model 14
Thanks Paul, its a good feeling when it turns out close to the image in your head before pulling it to bits. But its not a patch on the job you did on your 350
shifter
shifter
?
17 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 3 guests