Hi, I tried removing crank case filter which was super dirty but when tried to bolt it again the Allen bolt it has tread is a bit worn on engine side.
What taps to use on bike to make it good again ??
Allen Bolt Tread Worn Issue - Need Help
-
- Posts: 99
- Joined: Tue Apr 10, 2018 10:43 pm
- Location: Malta
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Allen Bolt Tread Worn Issue - Need Help
I think the thread size is 1 3/16 x 20tpi, Tracy Tools have a tap in stock, buy the CS Plug tap for £18, that is good enough.
https://www.tracytools.com/taps-and-die ... ct_id=1012
Check you have the spring and caps in the correct order.
Colin
https://www.tracytools.com/taps-and-die ... ct_id=1012
Check you have the spring and caps in the correct order.
Colin
only dead fish go with the flow
- Ozmadman
- Posts: 2651
- Joined: Wed Dec 14, 2011 1:02 am
- Location: ESSEX UK
Re: Allen Bolt Tread Worn Issue - Need Help
AND.... push some rag down the tunnel to ensure no swarf gets into the oil, not too far as there is an oil way drilling a little way down on the left
Paul
1960 Model 8
1974 Yamaha RD250B US Model 6 speed
1960 Model 8
1974 Yamaha RD250B US Model 6 speed
-
- Posts: 99
- Joined: Tue Apr 10, 2018 10:43 pm
- Location: Malta
Re: Allen Bolt Tread Worn Issue - Need Help
I have bought 1 3/16 as suggested but it is bigger than mine not good.
Any idea what is correct size and from where I get it.
Any idea what is correct size and from where I get it.
-
- Posts: 43
- Joined: Sat Sep 09, 2017 6:04 pm
- Location: west yorks UK
Re: Allen Bolt Tread Worn Issue - Need Help
Just measured (allen keyed oil filter) plug off mine( engine in bits ) and 1" diameter x 20 TPI .Tracy tools tap listed but cheaper ones seem to be out of stock ? If you get stuck you can make a tap if you know some one with a lathe . Turn threads on a bit of 1" silver steel and grind /file V slots and will do the job as a one off . Good luck .
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Allen Bolt Tread Worn Issue - Need Help
Darren, can I please apologise for my error, I must have picked up the wrong crankcase half and measured the thread of the oil tank filler not the filter, sorry.
Colin
Colin
only dead fish go with the flow
-
- Posts: 99
- Joined: Tue Apr 10, 2018 10:43 pm
- Location: Malta
Re: Allen Bolt Tread Worn Issue - Need Help
Hi,
Ok don't worry got another taps size 1" and fixed the issue.
Special Thanks to Tracy tools and all people here.
Darren
Ok don't worry got another taps size 1" and fixed the issue.
Special Thanks to Tracy tools and all people here.
Darren