Head stem and other parts.
-
Gazza1961
- Posts: 2
- Joined: Sat May 07, 2016 1:21 pm
- Location: Essex England
Re: Head stem and other parts.
Thank to you all for your replies. I now have footrests thanks to Clanger9. I also have the dimensions of the head stem (thank you oldandsmelly) so I can turn one up on my lathe. I'm going to turn up some "cups" to take taper roller bearings. that will get over the that problem. I'll let you know how it works out.
-
BultacoBen
- Member
- Posts: 107
- Joined: Sun Jul 12, 2015 9:48 pm
- Location: Bristol
Re: Head stem and other parts.
Hi Gazza, how did the fitting taper roller bearing and all that go?Gazza1961 wrote:Thank to you all for your replies. I now have footrests thanks to Clanger9. I also have the dimensions of the head stem (thank you oldandsmelly) so I can turn one up on my lathe. I'm going to turn up some "cups" to take taper roller bearings. that will get over the that problem. I'll let you know how it works out.
http://www.ben-eddings.com
1966 Matchless G2 CSR scrambler
1986 Suzuki DR600 long-range explorer
1971 BSA B50T street tracker
1966 Matchless G2 CSR scrambler
1986 Suzuki DR600 long-range explorer
1971 BSA B50T street tracker
-
Gary61
- Posts: 4
- Joined: Sun Sep 11, 2016 9:37 pm
- Location: Essex
Re: Head stem and other parts.
Only just got around to getting the bike on the bench, bought some taper roller bearings and have turned up cups to fit the headstock, just got to turn a washered bush to fit to the bottom yolk, and then the head stem, should work out OK. I'll post some pictures when I get them done.