nr1 magneto

Helpful information and requests for assitance and advice
Locked
magpie
Posts: 9
Joined: Wed Jan 11, 2017 8:45 am
Location: LINCS UK

nr1 magneto

Post by magpie »

Help!
Advice please on re timing my nr1 magneto.
I have a 18s special,that seems to want to
launch me into space when attempting to kick
start it.Advice please.

Magpie :roll:
User avatar
Rob Harknett
Member
Posts: 11236
Joined: Mon Jan 01, 1990 12:00 am
Location: ESSEX UK

Re: nr1 magneto

Post by Rob Harknett »

You do need to fully retard the lever when starting, or it will kick back violently. The reason for this is, timing is done with the lever in the fully advanced position. The points gap may have also opened , advancing the ignition a little. So check those two points first.
magpie
Posts: 9
Joined: Wed Jan 11, 2017 8:45 am
Location: LINCS UK

Re: nr1 magneto

Post by magpie »

Hi Rob
Thanks for your reply.Yes the lever is in the fully retard position,
, but will check the points first.the magneto is one that i am not
familiar with,so thourght it best to ask first,before tampering.
thanks again.

Magpie
alanengineer
Member
Posts: 1175
Joined: Wed Oct 12, 2005 10:45 pm
Location: KENT UK

Re: nr1 magneto

Post by alanengineer »

Are you timing your engine with the lever in the right position. Their is a slack wire and taught wire version of the N1 and both have to be treated accordingly
Radcap
Member
Posts: 133
Joined: Wed Oct 12, 2005 10:45 pm
Location: MANCHESTER UK

Re: nr1 magneto

Post by Radcap »

If the cable enters at the front of the mag ie near the frame slack is advanced. Pull to retard .
I set mine 50/50 when I start up then fully advance when it's started and leave it alone .
Mine is a Lucas nr1 mag
magpie
Posts: 9
Joined: Wed Jan 11, 2017 8:45 am
Location: LINCS UK

Re: nr1 magneto

Post by magpie »

HI All
First thanks to all replis.
I was told to push the advance/retard lever fully
forwards to start, but as the cable enters the mag
on the left when looking at it from the left hand
side, maybe I was misled. I could not see how to
remove the the points cover,and as i said i am not
familiar with the nr1, with the cover removed it
would be easy to see what was advanced or retard.
But as you get older it get hard just getting down,
and then you have to somehow get back up.
Thanks all.

magpie
leswaller
Posts: 615
Joined: Sun Nov 25, 2012 9:40 pm
Location: Chipping Norton

Re: nr1 magneto

Post by leswaller »

If the cable goes in from the left and front looking at the bike from the near side then you need to pull the lever right back towards you to retard the ignition. Tight cable equals retard and slack cable equals advance
Les
Rules are for the obedience of fools and the guidance of the wise
Locked