Hi everybody
As I'm rebuilding my engine (finaly) 194I G3L wonder if anyone have the correct measurement for the washer and the spacing collar betwen the two main ballbearings. SKF RLS8.
This engine has been manhandled in India, so what was in there when i took it apart, was certainly not the right stuff. I allso would like to know about the material. Steel or bronze.
I ask this because I'm on a limited budget, and have to save where I can. Given the right specs, I will fabricate these myself and thus save a little
Cheers
Spacer and collar betwen bearings
-
PFN
- Member
- Posts: 22
- Joined: Wed Jun 10, 2015 8:34 pm
- Location: DENMARK
-
Rob Harknett
- Member
- Posts: 11236
- Joined: Mon Jan 01, 1990 12:00 am
- Location: ESSEX UK
Re: Spacer and collar betwen bearings
http://www.matchlesswd.co.uk/2015/07/31 ... tchlesswd/
There is a WD Matchless forum, but do not think it is used much. Last and only? comment was 2015.
There is a WD Matchless forum, but do not think it is used much. Last and only? comment was 2015.
-
PFN
- Member
- Posts: 22
- Joined: Wed Jun 10, 2015 8:34 pm
- Location: DENMARK
Re: Spacer and collar betwen bearings
Thanks Rob.
I actually found the diameters on the two, in the manual, but the thicknes is not statet.I will look at the WD forum. I realy thought that I had this info, but pehaps it was just the measurements of the diameter that I just found again.
Cheers
I actually found the diameters on the two, in the manual, but the thicknes is not statet.I will look at the WD forum. I realy thought that I had this info, but pehaps it was just the measurements of the diameter that I just found again.
Cheers